Ver categorias
Explorar
Fiverr Pro
Português
$
USD
I will design compact esp32 s3 and esp32 c3 pcb layout and schematic
PCB Design ESP32 Arduino KiCad and IoT Hardware
I design PCB layouts and electronic schematics for makers, startups, and product developers. My services focus on ESP32 and Arduino boards, IoT hardware, sensor interfaces, circuit diagrams, and manuf...
Sobre este Serviço
Looking for a expert PCB designer to build a compact board using the latest ESP32-S3 or ESP32-C3 chips? I specialize in micro-sized, low-power ESP32 PCB designs built for IoT devices, wearables, and custom sensors.
Whether you need the high-performance ESP32-S3 with native USB and camera/AI support, or the cost-effective RISC-V ESP32-C3 for simple wireless node designs, I deliver factory-ready board layouts optimized for manufacturing.
What I Offer:
- Custom ESP32-S3 / ESP32-C3 circuit schematic design
- Ultra-compact multi-layer PCB layout & trace routing
- USB-C interface, LiPo battery charge/protection circuits
- RF Wi-Fi / Bluetooth antenna trace & impedance optimization
- Low-power sleep mode circuit optimization
Deliverables You Will Receive:
- Complete Gerber & NC Drill Files (JLCPCB / PCBWay ready)
- Detailed Schematic Diagram (PDF & Source Files)
- Bill of Materials (BOM with LCSC / Mouser part numbers)
- 3D STEP Models for 3D printed case fitting
Contact me before placing an order to discuss your exact project specs!
Perguntas frequentes
What is the difference between ESP32-WROOM, ESP32-S3, and ESP32-C3?
ESP32-S3 offers higher processing power, native USB, and camera/display capabilities. ESP32-C3 is a budget-friendly single-core RISC-V chip perfect for compact IoT sensors. I can help you choose the best one!
Can you design ultra-small, miniature PCB layouts for wearables?
Yes! I specialize in high-density, multi-layer placement to ensure your ESP32-S3 or C3 circuit board fits tightly inside small enclosures or wearable devices.
Is the output files ready for factory production?
Absolutely. You will receive production-ready Gerber, NC Drill, Pick & Place (CPL), and BOM files ready for fabrication houses like JLCPCB, PCBWay, or Seeed Studio.
Which software do you use to complete the design?
I primarily design in KiCad and Altium Designer. Full source files are included so you have complete ownership of your design.
What do I need to send you to start my project?
Simply provide your project goals, required sensors/peripherals, power source (USB or battery), and any size constraints you have.
