Ver categorias
Explorar
Fiverr Pro
Português
$
USD
I will design industrial iot, poe, stm32 and embedded hardware pcbs
PCB Embedded Systems Engineer STM32, ESP32 IoT
I’m an Electrical & Electronics Engineer focused on PCB and embedded hardware development for IoT products, controllers, prototypes, and electronic devices. I work with STM32, ESP32, Arduino, sensors,...
Sobre este Serviço
Need reliable PCB hardware for an industrial IoT, PoE, STM32, or embedded electronics project? I can help turn your schematic or hardware requirements into a clean, verified and manufacturing-ready PCB.
I work on controller boards, connected devices, sensor interfaces, Ethernet/PoE hardware, STM32 systems, power sections and other embedded electronics.
What I can provide:
- Schematic review and circuit support
- Component placement and PCB routing
- 2-layer, 4-layer and multilayer boards
- Power, ground and signal routing
- DRC/ERC checks and footprint verification
- Gerber, drill files, BOM and editable source files
- Manufacturing and JLCPCB preparation
I can work from an existing schematic, PCB source, component list or project requirements. Medical electronics and other specialized applications can also be discussed based on your project scope.
Send your requirements before ordering so I can confirm the board complexity and deliverables.
Perguntas frequentes
Can you work with an existing schematic?
Yes. I can review your schematic and use it as the basis for PCB placement, routing and manufacturing outputs.
Can you make STM32 and PoE boards?
Yes. STM32 controllers, PoE hardware, Ethernet interfaces and industrial IoT boards are within this Gig's scope.
Do you provide manufacturing files?
Yes. Depending on the package, deliverables can include Gerbers, drill files, BOM and editable source files.
Can you work with multilayer PCBs?
Yes. I can handle 2-layer, 4-layer and more complex multilayer boards depending on the project requirements.
Can you work with medical electronics?
Yes, for PCB and electronics engineering work. Please contact me first so the technical scope and requirements can be reviewed.
