I will design pixhawk h743 flight controller pcb for betaflight dual imu ardupilot inav
Electronics Product devloper
Sobre este Serviço
Does your flight controller drift, brown out on throttle punches, or show gyro noise you cannot tune out? Most flight problems start with IMU mounting, power noise and layout, not the PID settings.
I design STM32H743 flight controller PCBs for FPV, long-range, research and UAV projects, targeting Betaflight, ArduPilot and iNav hardware definitions.
Included:
- STM32H743 core: crystal, power, boot, USB-C and SD or flash logging
- Gyro/IMU design (ICM-42688, BMI270 class) with low-noise supply and soft-mount layout
- Barometer, OSD, current and voltage sensing
- 5 V and 9 V regulators sized for your battery cells
- UARTs, DShot motor outputs, I2C and optional CAN
- Standard 30.5 x 30.5 mm or custom mounting
- Schematic and layout in KiCad or Altium
- Gerber, BOM, pick-and-place, PDF schematic, 3D STEP
Firmware target files, tuning, certification and weaponized or military use are not included. Flight performance is not guaranteed.
Send your frame size, battery cells, sensors and firmware and I will confirm feasibility before you order.
Perguntas frequentes
Which firmware do you design for?
Betaflight, ArduPilot and iNav hardware, with PX4 quoted after review. I design to each firmware's supported peripherals and pin conventions.
Why the STM32H743?
It is a high-performance processor widely supported by flight firmware, with many UARTs, timers for motor outputs, and enough memory for logging and advanced features.
Which sensors do you support?
IMUs such as the ICM-42688 and BMI270 class, barometers, magnetometers, OSD chips and current and voltage sensing. Tell me the parts you prefer.
How do you reduce IMU noise?
A low-noise supply for the sensor, placement near the board center, clean routing, and a layout that suits soft mounting. Vibration also depends on your frame, props and motors.
Which software and files do you use and deliver?
KiCad or Altium, EasyEDA on request. You receive Gerbers, drill files, BOM, pick-and-place file, PDF schematic, a 3D STEP model and a firmware pin-mapping sheet.
Will it fly well, and do you tune it?
I cannot guarantee flight performance. Tuning and flight testing are not included. I design the hardware to support good performance.
Do you accept weaponized or military drone work?
No. I design hobby, research, survey and commercial drone hardware only.
