j
john_hnsonz

Hanson James

@john_hnsonz

RF PCB Design Engineer KiCad Altium MIDI Controller CM4 CM5 Automotive Repair

Reino Unido
Inglês
Algumas informações são exibidas no idioma inglês.
Sobre mim
I design RF and multilayer PCBs using Altium Designer and KiCad, covering impedance control, antenna integration, and full Gerber packages. My work spans custom MIDI controller hardware, Raspberry Pi CM4 and CM5 carrier boards, and automotive circuit board repair and reverse engineering. Every project is delivered with clean schematics, precise layouts, and fabrication ready files.... Saiba mais

Habilidades

j
john_hnsonz
Hanson James
offline • 
Tempo médio de resposta: 7 horas

Conheça meus serviços

Circuito Impresso (PCB)
I will design high frequency rf multilayer pcb impedance control antenna altium gerbers
A partir deUS$ 35 /projetoMais detalhes
Circuito Impresso (PCB)
I will design custom modular midi controller pcb rgb buttons faders firmware, enclosure
A partir deUS$ 100 /projetoMais detalhes

Experiência profissional

Electronicx

Electronics Design Engineer

Electronicx • Período integral

Jun 2017 - Present • 8 yrs 11 mos

Developed RF and mixed signal PCB designs for wireless communication modules, automotive ECUs, and IoT hardware. Worked with Altium Designer on high speed stackups, controlled impedance traces, and antenna placement. Responsible for schematic capture, layout review, signal integrity analysis, and coordinating Gerber deliverables with fabrication partners. Also handled PCB rework, component-level soldering, and fault diagnosis on automotive electronic modules.